Isoseal PSGG Gun grade polysulphide sealant
Isoseal PSGG is a two component polysulphide sealant designed for watertight seal.It has excellant adhesion to concrete, marble and granite . When cures it become flexible which can accommodate thermal and moisture movements.
|Chemical Base||Liquid Polysulphide polymer|
|Solid Content||100% by weight|
|Shore A Hardness @25Deg.||15-25|
|Application Temp||4-48 deg C|
|Setting time@35Deg||10 hrs|
|Full cure @35Deg||96 hrs|
The substrate must be clean, dry and free of all contamination such as dirt, oil, grease, coatings etc which hinder an adhesion. The substrate must be sound and of sufficient strength. There should not be any standing water and should be a cured surface.
Isoseal PSGG available in a ready to mix container .This material shall be mixed with a slow speed drill re supplied saparately.Pour the hardner into the base and mix thoroughly with a slow speed drill for 10 minutes. Immediately load the sealant into the gun fix the nozzle and srart extruding into the joint firmly .
Conditions of Use and Disclaimer The information contained in this Material Data Sheet is given in good faith based upon our current knowledge and does not imply warranty, expressed or implied. The information is provided and the product is sold on the basis that the product is used for its intended purpose and is used in a proper workmanlike manner in accordance with the instructions of the Product Data Sheet in suitable and safe working conditions. Under no circumstances will the Company be liable for loss, consequential or otherwise, arising from the use of the product.